Push Pole Mounting Brackets | Storage Clips
These rugged Push Pole Mounting Brackets are made of a durable, flexible urethane and can be attached to any surface to store your Superstick Push Pole during transport.*We only ship to the continental USA and are unable to sell to S.C. Residents.
*S.C. Residents: Please purchase our products from one of our fine local dealers.
Push Pole Mounting Brackets by Superstick®
- > These rugged Push Pole Mounting Brackets | Storage Clips are made of a durable, flexible urethane and make perfect push pole holders
- > Can be attached to any flat surface to store your Superstick Push Pole during transport
- > Slight concave base allows the tension of the prongs to be adjusted by simply loosening or tightening the push pole mounting brackets to the mounting surface
- > Push Pole Mounting Brackets hold 1″ to 1-1/4″ diameter poles
- > Sold in pairs
Installing Your Push Pole Mounting Brackets:
For many years of use your push pole should not be stored in direct sunlight. Also, we recommend the push pole be stored in the fully retracted position. Clip the push pole mounting brackets to the push pole (one clip close to each end will provide the most secure storage) and position the push pole in various places to find the most suitable location on the boat or kayak. When you find a good location, trace around the mounting brackets. Remove the clips from the push pole, position them over the traced areas and mark where a pilot hole should be drilled to attach the push pole mounting brackets. (The slight concave base allows the tension of the prongs to be adjusted by simply loosening or tightening the bracket to the mounting surface.)
If you can access the backside of the pilot hole, we recommend using a #8 or #10 pan head stainless steel screw and lock nut. If not, apply some type of silicone in the pilot hole and on the threads of a #8 or #10 stainless wood screw before screwing it in the boat or kayak. (That will help prevent the screw from backing out over time.) Stainless steel washers (used as spacers) can be added under the storage clips (with the screw passing through them), so you can tighten down on the screws, without applying too much tension to the prongs. Beware, it will make the push pole come out of the storage brackets easier. Whether you add the spacers or not, you should consider burning a small hole in the middle of some double-sided Velcro® and mounting it under the push pole mounting brackets. This will allow you to quickly provide additional security while trailering the boat / kayak or running to your next fishing location.